At present, China has applied some flue gas purification technologies such as wet, semi-dry, dry desulfurization, selective catalytic reduction denitration, wet combined desulfurization and denitration technology, electron beam method and so on.
These technologies are developed and applied only for one kind of pollutant, resulting in problems such as resource waste, large initial investment and high operating cost.
Therefore, it is an important subject for sustainable development to study the green and environment-friendly integrated flue gas purification technology with high efficiency, low cost and no secondary pollution.Activated carbon has a large specific surface area, good microporous structure, strong regeneration ability, is a good adsorption material.
Activated carbon can realize desulfurization and denitration at the same time, no secondary pollution and renewable utilization of resources.At present, the adsorption device of activated carbon adsorption process reported in the literature is mainly fixed bed, and this process has the disadvantages of large equipment, large bed resistance, poor continuity and so on.
In this paper, the activated carbon desulfurization and denitration test bed, with the circulating fluidized bed as the main adsorption device, the activated carbon desulfurization and denitration test study.Circulating fluidized bed flue gas purification technology can effectively avoid the shortcomings of the fixed bed adsorption process, such as complex equipment, large space occupied, and unstable bed resistance, etc., and the good cooperation with the bag filter can achieve the continuity of activated carbon adsorption and regeneration.gold adsorption on activated carbon
In this paper, the removal of SO2 and NO from flue gas by wood powdered activated carbon was studied in a pilot scale test rig.Some factors affecting the efficiency of desulfurization and denitration were analyzed through experiments, and economic analysis was made on the technology of combined desulfurization and denitration with activated carbon.>www.chinactivecarbon.com

Combined with unique flue gas generator and gas circuit switching and high rate of dilution technology, established a new type of impact based on the online detection of cigarette smoke aerosol particle size distribution of test method and the device, when implemented by suction mouth fresh smoke aerosol particle size size, concentration and distribution state of real-time detection, to evaluate the new additives, Cigarette auxiliary materials provide a new method for analyzing the effects of aerosol particles in smoke. After observing the stability of the device and the repeatability of the method, the aerosol particle size distribution characteristics of several activated carbon cigarette smoke were detected by using this method. It was found that the addition of activated carbon could effectively reduce the particulate matter content in the mainstream cigarette smoke, but had little effect on the particulate matter distribution state. The specific surface area and pore size distribution of activated carbon have a certain influence on the number concentration of aerosol particles. The higher the specific surface area, the stronger the adsorption capacity, and the less the number of particles. When the specific surface area is similar, the pore size distribution has an important effect, and the activated carbon with larger pore content is more favorable for the filtration of flue gas particles. The particle number concentration of seven samples of flue gas aerosol particles above 99% was concentrated in the range of 0.007~ 0.948um particle size, and the mass concentration was concentrated in the range of 0.262~ 9.910um particle size. Both particle number concentration and mass concentration showed an upward trend with the number of suction ports. The average particle number concentration of mainstream flue gas aerosol was 6.46×108~8.86×10° /cm' per puff, and the average mass concentration was 3.13×10+~ 3.85×10' mg/m' per puff. The total particle number concentration in a single cigarette was 3.88×109~5.31×10° /cm3. The total mass concentration ranged from 1.88×105 to 2.31×105mg/m3.gold adsorption on activated carbon
In order to further understand the effect of the pore structure of activated carbon on the filtration efficiency of cigarette mainstream smoke and the difference of the filtration efficiency between gaseous compounds and granular compounds, the adsorption selectivity of activated carbon on two important harmful components (sputum-based compounds and phenolic compounds) in cigarette mainstream smoke was also investigated. It was found that there was a significant correlation between the filtration efficiency of seven phenolic substances in the mainstream smoke of cigarettes and the filtration efficiency of particulate matter. The filtration efficiency of activated carbon for several monophenols was significantly higher than that of bisphenol, in which o-cresol had the highest filtration efficiency, followed by phenol. Activated carbon has a better adsorption effect on sputum-based compounds in the mainstream smoke of cigarettes. The larger the specific surface area of activated carbon is, the higher the filtration efficiency is. When the specific surface area is similar, the smaller pore size of activated carbon has a higher filtration efficiency. The activated carbon has the highest filtering efficiency for crotonaldehyde and the lowest filtering efficiency for acetaldehyde. The filtration efficiency of activated carbon for gas phase composition was significantly higher than that for granular phase composition. When the addition amount of activated carbon for six different pore structures was 23 mg/ branch, the total granular phase could be reduced by 3.75%-12.49%. The total phenolic compounds could be reduced by 2.92% ~ 13.68%. The total amount of sputum-based compounds could be reduced by 9.51% ~ 35.05%.>www.chinactivecarbon.com

"Activated carbon production and construction project" belongs to zhoukou xyz co., ltd. plans in zhoukou economic development zone (new) projects, proposed the project the total area of 25072.53 square meters about 37.59 acres), is expected to total investment of 95.0984 million yuan, including: investment in fixed assets of 83.8144 million yuan, flow capital of 11.284 million yuan, is expected to comprehensive income for 94.17 million yuan.
The economic situation this year is generally characterized by a steady but positive trend, and more positive changes have taken place in economic development.
Stability is reflected in the fact that the economy performed within an appropriate range, growth became more stable, and the quality and performance of the economy continued to improve.
The economic structure has continued to improve. Innovation is playing an increasingly important role in underpinning development. The service sector accounts for a larger share of the economy, and consumption is contributing more to growth.activated carbon manufacturers
Stability is also reflected in new breakthroughs in reform and opening up.The polishing slurry and processing technology of micro-abrasive slurry jet were studied.
Through the analysis of the physical and chemical properties of additives and their state changes under the jet, the comprehensive effects of the types and proportions of different additives, as well as the types, proportions and particle sizes of abrasive on the formation of uniform slurry, the promotion of good abrasive dispersion and the jet polishing effect were explored.
The effects of different types of nozzles, polishing slurry, jet distance, jet time, different initial RA, jet pressure and jet Angle on the surface profile, material removal depth and surface quality of the workpiece were studied through polishing experiments.powdered activated carbon (pac)
The local Ra of the optical glass surface is in the range of 20nm~50nm by MASJP, and the lowest Ra is 10.24nm.